Filter By Industry
Filter By Tag

Newsroom

Wilks Enterprise, Inc. Press releases

1 - 9 of 9 Press Releases

Jul 10, 2012
Meeting effluent limits for a NPDES (National Pollutant Discharge Elimination System) permit, complying with Clean Water Act for oil/grease limits, or satisfying a POTW’s (Publically Owned Treatment Works) permit, measurement reading can vary.

May 23, 2012
Several new videos from Wilks show the ease of using portable IR analyzers for measuring the level of oil and grease in water and with a few simple steps you obtain accurate part per million (ppm) results in under 15 minutes.

Mar 29, 2012
Determining total hydrocarbon levels to ensure compliance with regulatory permit requirements for discharging produced water is a problem for the oil and gas industry. InfraCal TOG/TPH Analyzers provide on-site measurements to ensure compliance.

Feb 27, 2012
Millions of gallons of water are used in and produced by hydraulic fracturing of shale gas wells which needs pretreatment to remove any residual oil. InfraCal TOG/TPH Analyzers allow on-site oil in water testing in less than 15 minutes.

Feb 14, 2012
On-site analysis of total petroleum hydrocarbons in soil is easily handled using the InfraCal TOG/TPH Analyzers. These infrared (IR) analyzers determine TPH levels in under 15 minutes. Levels from 10 ppm to over 20,000 ppm are accurately measured.

Feb 06, 2012
A White Paper by Wilks Enterprise addresses the common concern among biodiesel blenders and distributors as to whether or not biodiesel made from different feedstocks such as soy, waste vegetable oil or palm oil will affect the blend measurement.

Nov 30, 2011
Wilks InfraCal TOG/TPH Analyzers provide accurate, on-site analysis to help regulators and industry reduce the discharge of fats, oil and grease in wastewater. They provide on-site results in 10 minutes and are easy to use by non-technical personal.

Jul 12, 2011
A White Paper by Wilks Enterprise presents the advantages and cost savings for on-site analysis with a mid-IR analyzer, such as the InfraCal Ethanol Blend Analyzer, to help fuel blenders flag out-of-spec product and ensure final blend quality.

Jun 30, 2011
The InfraCal Soot Meter from Wilks Enterprise now gives users an approved easy-to-use ASTM testing method for measuring the percent level of soot in diesel engine lubricating oil.


Wilks Enterprise, Inc. RSS Feed