Filter By Industry
Filter By Tag

Newsroom

UltraFlex Power Technologies Press releases

31 - 40 of 177 Press Releases

Dec 03, 2021
This demonstration proved that the customer could successfully replace torch brazing with induction brazing. He could also take advantage of automation to increase his productivity rates and achieve consistent and high-quality brazing results.

Nov 26, 2021
The preheating process for each of the samples was successfully completed, with high energy- and cost-efficiency. Thanks to the lack of open flame, the preheating was a completely safe operation that did not require any specific environment.

Nov 17, 2021
The demo not only proved the possibility to heat all wire samples using induction, but also showed the time- and energy-efficiency of the process, which would allow to easily reach the predefined target productivity rates.

Nov 03, 2021
Thanks to the improved timing and energy efficiency for this heating process, the customer would achieve better productivity rates while at the same time benefiting from significantly reduced energy consumption.

Oct 20, 2021
The efficient usage of induction heaters for fast preheating to 1742°F/950°C of steel shovel molds has recently been demonstrated by UltraFlex Power Technologies.

Sep 23, 2021
By using induction, the customer would achieve a much improved time- an energy-efficiency for this annealing process and also ensure high-quality and repeatable results, independent of the operator skills.

Sep 14, 2021
By replacing torch-based brazing with induction brazing, the customer would not only achieve a time- and energy-efficient brazing process and increased productivity; he would ensure a process that is safe both for the operator and the environment.

Aug 24, 2021
The demonstration performed by UltraFlex showed how a specific and commonly challenging soldering process can be accomplished in a much more efficient manner using induction heating.

Aug 13, 2021
When used on the line, this induction de-brazing process would ensure time- and cost-efficient tip removal, resulting in higher productivity and lower costs compared to torch-debrazing.

Jul 30, 2021
At power output of 7.5 kW, the target brazing temperature of 1500°F (815°C) had been reached, for each of the assemblies, within a fraction of the time needed when torch brazing is used.


Page: Prev 2 3 4 5 6 Next
UltraFlex Power Technologies RSS Feed